Wordt geleverd met alleen headerpins (zoals afgebeeld)

Let op: R010 0,01 Ohm Shunt

Most current-measuring devices such as our current panel meter are only good for low side measuring. That means that unless you want to get a battery involved, you have to stick the measurement resistor between the target ground and true ground. This can cause problems with circuits since electronics tend to not like it when the ground references change and move with varying current draw. This chip is much smarter - it can handle high side current measuring, up to +26VDC, even though it is powered with 3 or 5V. It will also report back that high side voltage, which is great for tracking battery life or solar panels.

A precision amplifier measures the voltage across the 0.1 ohm, 1% sense resistor. Since the amplifier maximum input difference is ±320mV this means it can measure up to ±3.2 Amps. With the internal 12 bit ADC, the resolution at ±3.2A range is 0.8mA. With the internal gain set at the minimum of div8, the max current is ±400mA and the resolution is 0.1mA. Advanced hackers can remove the 0.1 ohm current sense resistor and replace it with their own to change the range (say a 0.01 ohm to measure up 32 Amps with a resolution of 8mA)

We include a 6-pin header (so you can easily attach this sensor to a breadboard) as well as a 3.5mm terminal plug so you can easily attach and detach your load. Usage is simple. Power the sensor itself with 3 to 5VDC and connect the two I2C pins up to your microcontroller. Then connect your target power supply to VIN+ and the load to ground to VIN-. We have an FOR Arduino library right now that will do all the gain, range and math for you - just plug and go! We'll have a more detailed tutorial up shortly.

INA226 High Precision Current and Bus-Voltage Monitor with I2C Interface
Maximum Measuring Range 0-36V and 0-3.2A
High Accuracy: 0.1% max. Gain Error, 10uV max. Offset
Power Supply 2.7 to 5.5V required (typical 0.33mA current consumption)
Arduino Library available on GitHub

Schrijf een beoordeling

Je moet inloggen of registreren om een beoordeling te plaatsen.

Stroommeter module DC 3.2A 36V max. digitaal I2C R010 0.01 Ohm Shunt INA226

  • Productcode: SEN-2003-INA22
  • Voorraad: 24
  • € 3,86

  • Excl. BTW: € 3,19

Beschikbare opties

Maximaal aantal per bestelling: 6

Tags: Stroommeter, module, DC, 3.2A, 36V, digitaal, I2C, INA226, R010, 0.01 Ohm, Shunt

Ps. Sommige producten hebben een maximaal bestelbaar aantal!
Sommige producten hebben een limiet op het aantal per bestelling, omdat wij deze producten aan zoveel mogelijk klanten willen aanbieden, of dat inkoop gerelateerd deze producten beperkt te verkrijgen zijn. Wij profileren ons niet als groothandel. Wilt u toch grotere aantallen bestellen van het desbetreffende product?, neem contact met ons op voor de mogelijkheden.